 |
|||
 |
|
|
|
|
|||
|
|
|||||||
| 4CS fork kit tools |
|||||||
1)
|
Picture of all tools needed ctg tube holder $60.00 8mm clamp block $30.00 24.6mm clamp block $30.00 push tool $5.00 set = $125 |
||||||
2) |
A push tool is needed to push the cartridge from the main chrome tube. The 4CS tool kit includes a 1 inch diameter x 12 inch long piece of plastic. |
||||||
3) |
The 24.6 mm clamp block is needed to hold the ctg tube while removing the seal assy. |
||||||
4) |
The 8 mm clamp block holds the cartridge assembly so you can work on the mv pist, valving etc. |
||||||
5) |
The base bolt can spin and not tighten with wrench. |
||||||
6) |
We recommend using a cartridge tube holder so you can tighten the base bolt by hand. Use caution if using impact wrench. |
||||||
7) |
The cartridge tube holder prevents the cartridge from spinning as the base bolt is tightened. |
||||||
|
